You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I have a 2wd automatic A4ld, I had a shifting problem, it would'nt go from 1st to 2nd. I replaced the Governor and the Intermediate Servo, and its been running fine for the last month or two.
When the above problem first started I had backed it out of my spot and put it in drive then I heard a grinding or clunking sound , I thought it was the driveshaft. I parked it checked the d-shaft and did'nt feel no play in the u-joints, so I started it back up and put it in reverse, it enguaged but would not move, even in nutrual, it would push forward but not back, brakes were new and ok. I did'nt think it was the linkage because it would go into gear when selected, I did have drive, but I was up to a wall and could'nt move.
About an hour later I tried reverse again and reved it and it started to move. after that , is when I had the shifting problem, so I replaced the fluid and screen again,( I had done that about a month before), and the gov and servo, and checked linkage.
Now the other day it kicked into reverse a little hard, (idle was only at 7-800) and when put in drive it sounded like the drive shaft again. then later it was ok. Have no money at this time, any ideas!!
This ad is not displayed to registered members. Register your free account today and become a member on FordForum!
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.
91 ranger tranny situation.
