2001 Ford Escape Gauge sweep at 3000 RPM
#1
2001 Ford Escape Gauge sweep at 3000 RPM
My son came home from college this weekend with an issue with his 2001 Ford Escape. During normal driving (*13.9 v) and you accelerate to >3000 RPMs to pass a vehicle, several instrument lights flicker, the instrument gauges sweep full down (counterclockwise) (*19 v), take foot off the accelerator, gauges stay a zero, then within seconds they rotate full up (Clockwise) (*18 v), then within a few more second they rotate full down and then almost immediately the gauges normalize (*13.9 v). The engine never skips a beat. If you progress smoothly from 2500 RPM through >3000 RPM nothing happen. If at this point you punch the throttle the anomaly happens.
*Alternator output monitored at the battery
Gauge Sweep during acceleration.
The engine light was not on when he came home after driving 200 miles. but did come out when he was out with friends. I checked the code and erased them and then I changed the oil pressure sensor. The engine light did not come on during the drive to get the above information.
Engine light is also intermittent and I came on during start after the sensor change. Not sure if the two issues are related.
When the engine light does locks you get these codes:
P0443 - Evap Emiss control sys purge valve
P0135 - O2 Sensor Heater cir. mal. (Bank 1 Sensor 1)
P0141 - O2 Sensor Heater cir. mal. (B1 S2)
P0155 - O2 Sensor Heater cir. mal. (B2 S1)
P0161 - O2 Sensor Heater cir. mal. (B2 S2)
Misfire, Fuel, Comp., Catlyst, Evap., O2 Siv Ser, O2 Heater, EGR
Erase the code and they may not come back for a month.
*Alternator output monitored at the battery
Gauge Sweep during acceleration.
The engine light was not on when he came home after driving 200 miles. but did come out when he was out with friends. I checked the code and erased them and then I changed the oil pressure sensor. The engine light did not come on during the drive to get the above information.
Engine light is also intermittent and I came on during start after the sensor change. Not sure if the two issues are related.
When the engine light does locks you get these codes:
P0443 - Evap Emiss control sys purge valve
P0135 - O2 Sensor Heater cir. mal. (Bank 1 Sensor 1)
P0141 - O2 Sensor Heater cir. mal. (B1 S2)
P0155 - O2 Sensor Heater cir. mal. (B2 S1)
P0161 - O2 Sensor Heater cir. mal. (B2 S2)
Misfire, Fuel, Comp., Catlyst, Evap., O2 Siv Ser, O2 Heater, EGR
Erase the code and they may not come back for a month.
Thread
Thread Starter
Forum
Replies
Last Post
PDEvans
Windstar/Aerostar
1
01-22-2007 02:13 AM